Punch Down Tool Of Network Cabling Tools

A krone punch down tool(also known as punchdown tool or krone tool) is needed to quickly and efficiently connect cable wires to electrical contacts. Not only do these tools make faster connections, but because many connecting blocks like 66-type or 110-type are designed for use with these punch down tools.

AMP Standard Impact Tool  for 110 Connect Terminations

It’s not only a cable crimp tool for terminating Cat 5, 5e or 6 cables, but it also will punch down a 110 IDC RJ45 jack. It’s a quality piece of equipment. To successfully create Ethernet jacks that computers connect to and for terminating Ethernet cables in a way that does not impair the data signal, IT workers need the right tools. Crimpers are used to terminate RJ45 heads—the little plastic plugs that allow an Ethernet cable to fit either into an RJ45 wall jack or the Ethernet port on a computer. Crimpers that did not have the right amount of pressure to make a good crimp as well as the sometimes-flimsy punch down tool that comes with RJ45 jacks—making wiring time-consuming and frustrating.

Common Features Of Punchdown Tools

Tipical on the market there are three different punch down tools available, including standard impact tool, universal automatic impact tool and corrosion resistant termination tool. Most punch down tools are of the impact type, consisting of a handle, an internal spring mechanism, and a removable slotted blade. They typically are 6-8 inches long with a blade at one end. The top and bottom of the tool are usually different colors to help users identify which side is used to cut the wire. Most models have a changeable blade and a pressure adjustment screw or knob.

The dimensions of the punch down tool are not standardized. Some tools measure 5.35 in x 1.06 in x 1.06 in and weigh 4.69 oz. Others have dimensions of 5.25 in x 1.26 in x 1.26 in, 7.00 in x 2.02 in x 2.02 in and so on. Their weights also vary. Whatever the dimensions of the punch down tool are, usage is the same.

How To Use A Punch Down Tool?

1. Prepare to punch down a wire.
Standing in front of the connection block, hold the punch down tool in one hand, with the cutting blade facing down. Hold the wire in your other hand and loop it through the selected connection block terminal.

2. Punch down the wire.
Holding the end of the wire firmly, place the blade of the punch down on the selected connection terminal and push forward until you reach the bottom of the terminal. Continuing to hold the end of the wire, punch the tool firmly with a straight-forward motion. If done correctly, this action should connect the wire to the terminal and cleanly cut off any excess.

3. Check your connection.
Make sure your connection is secure and there is no loose or broken wire left in the connection block. Tug on the wire to verify that it is securely fastened and connected to the correct terminal.

There are many types of punch down tools available and have different features. The good ones will have reversible blades. This can be handy in many instances. It is also important for the blade to fit in properly. The tool must also be robust. Find other fiber optic tool at FiberStore.

This entry was posted in Punch Down Tool and tagged , , . Bookmark the permalink.

Leave a Reply